The cloud admin account of AVS holds minimal administrative privileges, which might impede the manual installation of JetDr This article describes the process to install JetStream DR software in an AVS environment.
Issue
The AVS Cloud Admin account is granted limted administrative privileges that can impede manual installation of JetStream DR components (such as registering plugins, installing IOF IOFilters, etc). To overcome this challenge, we have implemented specific a set of AVS Run commands are provided to automate and facilitate a seamless JetDr installation and configuration process.
This article elucidates the process of installing JetDr within an AVS environment.
...
of JetStream DR software.
Installation
Step 1: Log in to the Azure portal (portal.azure.com)
Step 2: Navigate to the AVS private cloud platform where the deployment of JetDR is neededJetStream DR software is intended to be depolyed.
Step 3: Look for Locate the Run command in the left panel and then click on it.
...
Step 4: Under the packages Packages select JSDR.Configuration.
...
Step 5: From the dropdown of JSDR.Configuration select Install-JetDRWithStaticIP.
...
Info |
---|
...
Alternatively, JetStream DR can |
...
be configured using DHCP |
...
. To do this, use the Run command |
...
Install- |
...
JetDRWithDHCP instead. |
Step 6: From Complete the Run Command form fill in the details accordingly.
...
Note |
---|
If the DNS is not configured or resolving properly explicitly enable RegisterWithIp (as shown above). |
...
form by entering all necessary details then click the Run button.
...
Info |
---|
Required Fields and the description. descriptions: Protected Cluster → Name of the AVS cluster which is going to be protected. |
Note |
---|
If DNS is not configured or resolving properly, enable the RegisterWithIp option (shown below). |
...
Step 7: The Run command status can be monitored at “Run under “Run execution status.”.
...
Additional details
about a Run command execution can viewed by selecting
its Execution name.
The current status of Run command execution
can be viewed
in realtime from the
Information panel.
After completing the steps above, refresh the vCenter instance for changes to the
JetStream DR plugin to
take effect.
Remaining configuration can be done directly from within the
JetStream DR UI.
(vCenter → Datacenter → Configure → JetStream DR)
...
...
...
...
...
...
...
Infonote |
---|
If the JetDR has to be applied for JetStream DR will be deployed to multiple clusters under within a single DC, then execute use the Run command “Enable-JetDRForCluster” (please refer to the below image). .” This has to be executed per cluster (- one at a time (shown below). |
...
Step 8: After successful completion of the above steps
...
...
...
...
...