Versions Compared

Old Version 10

changes.mady.by.user Syed Sarfraz Hussain

Saved on

compared with

New Version 11

changes.mady.by.user Syed Sarfraz Hussain

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Step 6: From the Run Command form fill in the details accordingly.

...

Note

If the DNS is not configured or resolving properly explicitly enable RegisterWithIp (as shown above).

...

Info

For more details on the above fields and installation please refer https://learn.microsoft.com/en-us/azure/azure-vmware/deploy-disaster-recovery-using-jetstream Required Fields and the description.

Protected Cluster (Name of the AVS cluster which is going to be protected)
DataStore (Name of the datastore where the JetStream MSA will be deployed)
VMName (Name of JetStream MSA VM, for example, JetStreamServer).
Cluster (Name of the AVS cluster where the JetStream MSA will be deployed)
MSAIP (IP address of the JetStream MSA VM)
DNS (DNS IP that the JetStream MSA VM should use)
Gateway (IP address of the network gateway for the JetStream MSA VM)
MSA Credentials (Credentials of the root user of the JetStream MSA VM)
HostName (Hostname (FQDN) of the JetStream MSA VM)
Network (Name of the NSX-T Data Center network segment where the JetStream MSA will be deployed)
Retain Up to (Mention for how many days we want to retain the run command execution)
Specify name for execution (Alphanumeric name of the execution, It is used to verify if the cmdlet ran successfully and should be unique for each run).
Timeout (Mention the timeout value for the Run command to be executed)

Step 7: The Run command status can be monitored at “Run execution status”.

...

More details on Run command execution can viewed by selection selecting the desired execution name (as shown below).

...

The live Run command execution state can be viewed under the information panel (below is the reference).

...

Info

If the JetDR has to be applied for multiple cluster clusters under a single DC, then execute the Run command “Enable-JetDRForCluster” (please refer to the below image). This has to be executed per cluster (one at a time).

...

Step 8: After successful completion of the above steps, refresh the vCenter instance for the JetDR plugin to be reflected.

Step 9: Remaining The remaining configuration can be done directly from the JetDR UI (vCenter → Datacenter → Configure → JetStream DR)

Info

If any issues are observed please reach out to JetStream support
/wiki/spaces/KBDR/pages/2784657420

...